KitchenAid 30'' Electric Cooktop KECC607BBL02

30" ELECTRIC COOKTOP WITH 4 RADIANT ELEMENTS AND TOUCH-ACTIVATED CONTROLS

This ceramic-glass cooktop features touch-activated controls that add to its sleek design. Even-Heat™ Technology is found on all elements. You’ll get consistent temperatures without hot or cool spots and a range of simmer and melt settings. To maximize the 30-inch space, you get a triple-ring and double-ring element that lets you match element performance to cookware size.

PRODUCT DIMENSIONS

A. Glass depth - black and white models - 213⁄4" (55.2 cm)

Glass depth - stainless steel models - 221⁄8" (56.4 cm)

B. Glass width - 30" (76.2 cm) models - 3013⁄16" (78.4 cm)

Glass width - 36" (91.4 cm) models - 365⁄16" (92.3 cm)

C. Frame depth - 201⁄4" (51.5 cm)

D. Frame width - 30" (76.2 cm) models - 2815⁄16" (73.5 cm)

Frame width - 36" (91.4 cm) models - 347⁄16" (87.5 cm)

E. Cooktop height - 33⁄4" (9.6 cm)

F. Cooktop height including conduit (located at rear of

cooktop, right side) - 51⁄4" (13.5 cm)

Before You Make the Electrical Connection:

To properly install your cooktop, you must determine the type of electrical

connection you will be using and follow the instructions provided for it here.

● A 3-wire or 4-wire, single phase, 120/240 volt, 60-Hz., AC only electrical

supply is required on a separate, 40-amp circuit fused on both sides of the

line. The model/serial number rating plate is located on the metal cabinet

underneath the cooktop. See the following illustration.

● The cooktop is rated 120/240 volt. Most models have a neutral (white) wire.

Model W5CE3024 does not have a neutral (white) wire.

● The cooktop should be connected directly to the junction box through

flexible, armored or nonmetallic sheathed, copper cable. The flexible, armored

cable extending from the fuse box or circuit breaker box should be connected

directly to the junction box.

● Locate the junction box to allow as much slack as possible between the

junction box and the cooktop so that the cooktop can be moved if servicing

becomes necessary in the future.

● Do not cut the conduit. Use the length of conduit provided.

● A UL listed or CSA approved conduit connector must be provided at each end

of the power supply cable (at the cooktop and at the junction box). A listed

conduit connector is already provided at the cooktop.

● If the house has aluminum wiring, follow the procedure below:

1. Connect a section of solid copper wire to the pigtail leads.

2. Connect the aluminum wiring to the added section of copper wire using

special connectors and/or tools designed and UL listed for joining copper

to aluminum.

Follow the electrical connector manufacturer's recommended

procedure. Aluminum/copper connection must conform with local

codes and industry accepted wiring practices.